Sewage Lift Pump
I have a sewage lift station. The float sometimes fails to activate. Is there a secondary backup switch?
The lift station pump is controlled by a single float. Can a “backup” float or switch be installed that would activate if the primary float does not?
Yes there are back-up float switches available, not at HD or Lowes, but from plumbing supply houses.
Lift Station Installation and Sewage Pump Sales in Florida – Florida Keen Sewage Pump Distributor
|
|
Weil Pump Sewage Lift Stations 1967 print Ad $10.00 |
|
|
NORWECO WASTEWATER PUMP UNIT – Sewage Lift Station SIMPLEX 1/3 HP PUMP SC-103 $1,369.00 |
|
|
NORWECO WASTEWATER PUMP UNIT Sewage lift SIMPLEX 2 HP GRINDER PUMP MODEL GB320 $4,150.00 |
|
|
NORWECO WASTEWATER PUMP UNIT DUPLEX 1/3 HP PUMP – Sewage Lift Station SC103 $2,565.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT DUPLEX 2 HP GRINDER PUMP MODEL GB320 $6,595.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT Station SIMPLEX 2/5 HP PUMP MODEL SC104 $1,260.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT SYSTEM DUPLEX 2/5 HP PUMP MODEL SC104 $2,599.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT SYSTEM SIMPLEX 1/2 HP PUMP MODEL HB105 $1,470.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT DUPLEX 1/2 HP MODEL HB105 Stainless $2,585.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT SYSTEM SIMPLEX 1/2 HP PUMP MODEL SC105 $2,460.00 |
|
|
NORWECO WASTEWATER PUMP UNIT SEWAGE LIFT SYSTEM DUPLEX 1/2 HP PUMP MODEL SC105 $4,350.00 |
|
|
Superior Pump 92341 /3 HP Cast Iron Sump Pump Side Discharge with Vertical Float Switch $84.00 1/3HP split capacitor motor – high efficiency – low draw, 100 percent cast iron construction, 10′ grounded water proof power cord, pumps up to 46 gallons per minute, 2760 gallons per hour, side and bottom intake provides for clog resistant suction, vertical float switch with piggy back plug included, cooler operating 115V motor provides continuous duty, pump will lift water over 25 ft. vertical he… |
|
|
Wayne RPP50 Cast Iron Sewage Pump with Tether Switch $134.99 Upper ball bearing for quiet operation and long life. Ideal for basement or below grade installations. Application: Pump, Flow (GPH): 5,700, Volts: 120, Amps: 15, HP: 1/2, Discharge Port (in.): 2, Pump Housing: Cast iron, Volute: Cast iron, Impeller Shaft: Vortex, Seals: Mechanical, Solid Handling (in.): 2, Thermal Overload Protection: Yes, Dimensions L x W x H (in.): 6 1/2 x 9 1/2 x 15… |
|
|
Zoeller M267 Waste-Mate Sewage Pump, 1/2 Horsepower, 115V $291.19 Zoeller 267 Waste-Mate Submersible Sump Pump for Sewage/Effuent or Dewatering1/2 HPSingle phase, 115V10 ft cordFloat operated, submersible (NEMA 6) 2-pole mechanical switchDurable cast construction, ASTM Class 25 cast iron, switch case and pump housingCast iron baseNon-Clogging Vortex Impeller Design. Cast iron impepeller, stainless steel screws, bolts, handle, guard and arm and seal assemblyNeopr… |
|
|
Pumping Station Design, Second Edition $56.20 This award-winning book is written for a variety of potential readers; the expert and the beginner in the design office, members of a design team, the city engineer or chief engineer of a water or sewerage authority (or their subordinates) who may review plans and specifications, and manufacturers and their representatives who should know how their equipment will be used in practice.Each author or… |
|
|
Jabsco 18590-2092 Marine Run-Dry Heavy Duty Macerator Waste Pump (12-Volt) $134.39 The Jabsco 18590 series DC macerator waste pump is the ideal solution for boaters who need to empty marine holding tanks when not in a discharge-restricted area. Self-priming to 5 feet, the pump will empty a typical 30-gallon (115-liter) holding tank in less than three minutes. The pump’s duty cycle, meanwhile, is 15 continuous minutes, which means you can empty a 180-gallon (680-liter) pump in a … |
